Watts DWB Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques Watts DWB. Watts DWB User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Model 2M2 DWB
Duo-Clozure
Washing Machine Wall Box
Installation Instructions
Description
The Watts Model 2M2 DWB Duo-Clozure Washing Ma-
chine Wall Box (Fig. 1) consists of a molded plastic enclo-
sure with top and side knockouts that accept the hot and
cold water supply piping as well as a 1
1
2” and 2” drain
knockout to accommodate the waste drain pipe. The
Duo-Clozure also comes with mounting straps for secur-
ing the box to wall studs. The Duo-Clozure incorporates
a Watts Model 2M2 Duo-Cloz™ Washing Machine Shutoff
valve that simultaneously controls the  ow of both hot
and cold water to the appliance. The Duo-Clozure trim
plate can be decorated to blend in with the wall  nish.
Installation
CAUTION: Be sure to install the Duo-Clozure so that the
“On-Off” lever is above the top of the washing machine.
1. Determine the location to install the Watts Duo-Clozure
wall box, Fig. 2. Be sure that the Duo-Cloz valve lever
is located above the top of the washing machine and is
accessible to operate the valve.
(Suggested minimum height from the bottom of the
mounting straps to the  nished oor is 41 inches,
Fig. 3.)
Figure 1
Figure 3
Figure 2
Finished Wall
10
3
16" Min.
2
1
2"
Min.
2
1
2"
6" Max
5
3
16" Min.
3
4" Typical
IS-2M2 DWB
Finished Floor
Mounting Strap
42" Min.
To Box
Centerline
41" Min.
To Bottom
of Bracket
IS-2M2 DWB.indd 1 9/24/08 9:09:35 AM
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Washing Machine Wall Box

Model 2M2 DWBDuo-Clozure™ Washing Machine Wall BoxInstallation InstructionsDescriptionThe Watts Model 2M2 DWB Duo-Clozure Washing Ma-chine Wall Box (F

Page 2 - 2" Drain Pipe

2. Prior to mounting the box, determine which inlet po-sition will be used (side or top), and remove the ap-propriate knockouts. Then determine the d

Page 3

Figure 6Figure 7Figure 8Stop Valve Position (if required)Trim Wall BoxTo AccomodateStop Valve4. Level the wall box and fasten it to the wall stud-din

Page 4 - © Watts, 2008

Figure 10Figure 11Figure 9Note: The Duo-Clozure™ trim plate can be decorated to blend in with the  nished wall. The Duo-Cloz operating lever will a

Commentaires sur ces manuels

Pas de commentaire